Skip to main content
Unique Wood Products

Hard Maple — hardwood for stair treads and millwork

Creamy white to light amber. The harder maple: dense, wear-resistant, and distinct from Soft Maple.

Hard Maple plank, clear matte finish
Janka hardnessHard

1,450 lbf

Hard and tight — hard maple, not soft. Good under traffic, and the same density is what makes it blotch under stain.

Cost indexMid

133 · red oak = 100

Computed from the wholesale price schedule for the 1″ 8070 tread program.

Availability

Core catalog · availability confirmed at quote

Milled and finished at the Tanner Rd mill, NW Houston. Every wood stair part is special order.

What we mill it into

Character

Fine, tight, and even.

Hard and tight — hard maple, not soft. Good under traffic, and the same density is what makes it blotch under stain.

Best for

Clear-finish trim, cabinetry, stair parts, and custom profiles.

How Hard Maple behaves in service

Every board moves with the seasons, and in Houston the swing from a humid summer to a heated winter is the widest a floor or a tread will see. The figures below are the published shrinkage constants; the movement calculator turns them into inches for a given width.

Tangential shrinkageHigh movement

9.9%

Across a flatsawn face, green to oven-dry. The larger of the two and the one a wide plank follows.

Radial shrinkage

4.8%

Across a quartersawn face. Rift and quartered stock moves this much, which is why it is the stable cut.

Basis

USDA Wood Handbook

Published laboratory constants for the species, not a UWP measurement.

Finishing

Blotches under pigment stain because the dense grain takes colour unevenly; a conditioner, a dye or a clear coat is the usual answer. Under lacquer it reads almost white.

Machining and fastening

Burns on a dull cutter and shows every tool mark, so it is milled with sharp knives and a slow feed. Turns beautifully and holds a screw hard.

Closest in hardness

The three species nearest Hard Maple on the Janka scale — the usual alternatives when a budget, a tone or a lead time rules it out.