Know how much it’ll move.
SEASONAL SHRINKAGE & SWELLING · USDA WOOD HANDBOOK · HOUSTON-TUNED
Flatsawn coefficient: 0.00369 per 1% MC (Wood Handbook Table 13-5).
Actual face width of one board or plank.
At install.
In service.
Seasonal scenarios
End-grain cross-section
Red Oak · 5.00″ wide · 11% → 7% MC
Movement
shown ×4 for clarity
Red Oak: 5.00″ wide; 0.074″ shrinkage. Movement is exaggerated ×4 in the drawing; wood appearance is illustrative.
Width change
0.074″
Shrinks (narrower)
Nearest 1/32″
1/16″
Shop-readable
Across the board
1.48%
Red Oak · 4% MC swing
What this means
This board shrinks about 1/16″ across its width. Actual joint gaps depend on the installation, fastening and moisture conditions.
Estimates use flatsawn (tangential) coefficients from the USDA Wood Handbook, Table 13-5 — the conservative worst case. Quartersawn boards move roughly half as much. Real-world movement depends on finish, install, and site conditions; measure with a meter for critical work.
Reference
How much a board moves, and why it matters in Houston
- How do you calculate wood shrinkage?
- Change in width equals board width × the species dimensional-change coefficient × the change in moisture content. A 5-1/2" white oak board going from 11% to 7% moisture — a normal Houston summer-to-winter swing — loses about 0.100", near 3/32". Across ten boards that is nearly an inch of accumulated gap.
- Why does this use tangential and not radial values?
- Tangential is the larger of the two coefficients, so it is the conservative case, and it is what governs the gapping and cupping you actually see. Flatsawn stock moves tangentially across most of its width. Quartersawn moves closer to the radial figure and is meaningfully more stable, which is part of what you pay for.
- What moisture range should I plan for in Houston?
- The presets use 11% for a humid summer install and 7% for a heated dry winter. That four-point swing is typical for a conditioned interior here. An unconditioned space — a garage, a room before HVAC is running — swings considerably wider, which is why flooring should not be installed before the building is closed and conditioned.
- Where do the coefficients come from?
- The USDA Forest Products Laboratory Wood Handbook, Table 13-5. They are the published tangential dimensional-change coefficients for each species and are valid between roughly 6% and 14% moisture content, which covers normal interior service.
- Which species moves least?
- Of what UWP mills, walnut and cherry are the most stable, then maple, then white oak and red oak, with hickory moving most. If a wide flatsawn board in a room with big humidity swings worries you, the species choice matters as much as the acclimation.

