Moulding family
Bed Moulding
3 profiles
Bed mould is crown’s smaller cousin: a sprung profile, usually under 2-1/2″, that sits in the angle between wall and ceiling on its own or under a crown as part of a built-up cornice. On an 8 ft ceiling a bed mould alone is often the right call where a full crown would crowd the room.
Stocked in solid hardwood. Installed sprung like a crown, so the spring angle on each profile page is the number for the saw.

Bed Moulding
1-11/16" × 2-3/16"
Special orderView profile →Bed Moulding
1-15/16" × 1-13/16"
Special orderView profile →
Bed Moulding
9/16" × 1-3/4"
Special orderView profile →Terms used on this page
Questions people ask before ordering
Crown vs. cove moulding — what’s the difference and which one do I need?
Crown moulding is sprung — it sits at an angle bridging the wall and ceiling, with an ornate profile that can include curves, beads, and steps. Cove moulding is a single concave curve, sitting flat into the wall-ceiling corner. Crown reads as traditional and substantial; cove reads as clean and quieter. For 8-foot ceilings, cove or small crown. For 9-foot+, scale up.
Read the answer →Cabinet crown molding vs. room crown — how do they work together?
Cabinet crown molding sits on top of upper cabinets, finishing the cabinet-to-ceiling transition. Room crown moulding runs along the wall-ceiling seam around the rest of the room. These two crowns typically don’t coexist in the same kitchen — the cabinet crown is the dominant ceiling treatment when present, and room crown would visually compete. Use cabinet crown in kitchens with upper cabinets that reach close to the ceiling; use room crown elsewhere.
Read the answer →What size baseboard works with 9-foot ceilings?
For 9-foot ceilings, the standard recommendation is a 5-1/4″ to 7-1/4″ baseboard — roughly 5% to 8% of ceiling height. 5-1/4″ keeps the room feeling modern and uncluttered; 7-1/4″ reads as traditional and substantial. Don’t go below 4-1/4″ on a 9-foot ceiling; the proportions look pinched. Match the casing scale — bigger base wants 3-1/2″ or wider casing.
Read the answer →Can you match my existing moulding profile?
Yes. UWP runs custom knives to match existing baseboards, crown, casing, and any other milled profile. Bring us a 6-inch sample piece, a clean sketch with dimensions, or even a photo with a scale reference. We grind a new knife to match, run your order, and keep the knife on file for re-orders. One-time knife fee covers the setup; per-foot pricing matches our stock catalog.
Read the answer →

