Skip to main content
Unique Wood Products

Moulding & trim

Crown moulding

A moulding installed at the junction of wall and ceiling, sprung at an angle between the two.

Crown is not flat against either surface. It sits at an angle, touching the wall along one edge and the ceiling along the other, with an air gap behind — which is what gives it its projection and its shadow.

That angle is the spring angle, and it governs every cut. The common ones are 52/38 and 45/45, and the saw settings for mitres and copes differ between them, which is why a crown cut to the wrong assumed spring angle will not close.

Because ceilings and walls are rarely square to one another, inside corners are usually coped rather than mitred.

On this site

Questions that use this term

See also

More in moulding & trim

Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.