Skip to main content
Unique Wood Products

Moulding & trim

Spring angle

The angle at which a crown moulding sits between wall and ceiling, which sets every saw angle used on it.

Spring angle is measured between the back of the moulding and the wall. It is a property of the profile, not a choice made on site: a 52/38 crown meets the wall at 52 degrees and the ceiling at 38.

Every mitre and bevel setting follows from it. Cutting a 52/38 crown on 45/45 settings produces joints that look almost right and will not close, which is the single most common crown installation failure.

Crown can be cut nested — held against the fence at its spring angle — or flat, with compound settings. The second is faster on wide stock and less forgiving.

On this site

Questions that use this term

See also

More in moulding & trim

Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.