Skip to main content
Unique Wood Products

Crown, before you cut.

LINEAR FEET · STOCK PIECES · COMPOUND MITER & BEVEL CHART

Long wall, wall to wall.

Short wall, wall to wall.

Almost always 90°. Change only for angled / bay walls.

UWP runs custom crown in long lengths to cut seams.

Optional. Leave blank to skip cost.

Crown: 10–15% (miter offcuts).

Your room — top down
50.0′ perimeter · crown runs the full wall line
14.0′11.0′

Crown is shown at the ceiling perimeter; profile size and corner positions are illustrative.

Perimeter
50.0 ft
2 × (L + W)
Linear ft (order)
56.0
Includes 12% waste
Stock pieces
5
12′ lengths · verify cuts fit each wall
Compound miter — saw settings (crown flat on table)
38° spring · 90° corner
Miter angle
31.6°
Saw table swing
Bevel angle
33.9°
Blade tilt
CEILINGWALL38°

Inside corner
Use the included angle between the walls. Left and right pieces need opposite saw directions; follow the saw maker’s crown-cut orientation chart.

Outside corner
Use the smaller angle between the wall faces, not a reflex angle above 180°. Confirm the keeper side and test-fit both cuts on scrap.

Nested method
Crown held against the fence at spring angle: simple miter 45.0°, no bevel.

Need it milled? UWP runs custom crown across its core material program — matched to your existing trim.

Request a quote →

Visual and cut angles are guides for square-cut, flat-on-the-table crown work. Field-verify every corner — old houses are rarely true 90°. Final mill list is built per order.

Reference

Spring angle, and the two numbers on the saw

What miter and bevel do I set for 52/38 crown?
Cutting flat on the saw table at a 90° corner: miter 31.6°, bevel 33.9°. Those come from the spring angle, not the crown’s face profile — 52/38 crown springs 38° off the wall.
What about 45/45 cove crown?
At a 90° corner, miter 35.3° and bevel 30.0°. Different from 52/38, which is why cutting a cove crown on settings meant for standard crown produces a gap that no amount of caulk hides.
What is spring angle and why does it matter more than the size?
Spring angle is how far the moulding leans off the wall when it is seated against wall and ceiling. It, plus the corner angle, is the whole calculation — a 3" and a 7" crown with the same spring angle take identical saw settings. Measuring it on a scrap is the fastest way to be sure.
How do I cut a corner that is not 90 degrees?
Measure the actual corner and enter it. At 38° spring, a 135° corner needs miter 56.1° and bevel 17.6°. Framed walls are rarely exactly square, so measuring beats assuming — especially on a long run where the error accumulates.
How much crown should I order?
Take the room perimeter, then add waste for the corner cuts: 10% for a simple rectangular room, 15% where there are many corners or the stock length forces awkward splices. Order full lengths that let you run each wall in one piece if you can — a scarf joint in the middle of a wall is visible in raking light.