Moulding & trim
Shiplap
Boards with a rabbet along each edge so they overlap and leave a consistent gap between faces.
Shiplap joints by overlapping rabbets rather than by a tongue in a groove. The overlap gives a positive location and a controlled gap — the nickel gap named for the coin traditionally used to set it.
It is simpler to make and to install than tongue and groove, and more tolerant of movement, but it does not lock the boards together across the joint.
On this site
Questions that use this term
- How much shiplap do I need, and how does the reveal change the coverage?
- Shiplap vs. tongue and groove — what’s the actual difference, and which should I use?
- Wainscoting styles — beadboard, shiplap, board-and-batten, raised panel. Which one for my room?
- What does "milled to order" actually mean, and what does the mill need from me?
See also
More in moulding & trim
Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.

