Moulding & trim
Rabbet
Also called rebate
A stepped recess cut along the edge of a piece, open on two faces rather than enclosed.
A rabbet is a two-sided notch along an edge. It appears in shiplap joints, on the back of a landing tread where it laps the floor, under an overlap reducer, and wherever one piece has to sit down onto another.
It differs from a groove, which is cut into the middle of a face and is enclosed on three sides.
Questions that use this term
See also
More in moulding & trim
Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.

