Moulding & trim
Overlap reducer
Also called reducer
A transition moulding that ramps down from a thicker floor to a thinner adjacent surface.
A reducer bridges a change in floor height — hardwood meeting vinyl, tile or concrete. It laps over the thicker floor with a rabbet on the underside and ramps down to the lower surface.
Where the transition sits on an accessible route, the geometry is governed rather than cosmetic: there are limits on an unbevelled vertical change, on the slope of a bevelled one, and a threshold beyond which the change must be ramped.
The drop under the lip has to match the floor thickness it laps, so a reducer is specified against both floors, not one.
On this site
Questions that use this term
See also
More in moulding & trim
Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.

