Skip to main content
Unique Wood Products

What is a window stool, and do I need an apron with it?

The stool is the interior sill — the horizontal board the side casings land on. The apron is the trim directly beneath it, closing the wall under the sill. The stool is rabbeted on its back edge to fit the sash, so it is matched to the window; the apron is usually the casing profile run upside down.

The short version

  • Stool — the interior sill. Horizontal, thicker than the casing, eased or bullnosed on the front edge.
  • Apron — the trim under the stool, closing the wall beneath the sill. Usually the casing profile, run upside down.
  • The rabbet is the fitting dimension. It is cut to the sash, so a replacement stool is measured at the window, not matched to the room.
  • Length: the stool runs past the casing at both ends with a small horn; the apron runs from the outside of one casing leg to the outside of the other.
  • Picture-frame casing — four legs mitred around the opening — has neither piece. That is a choice, not an omission.

The full answer

Window trim is the one place where a horizontal piece does real work. The stool is the interior sill: it holds plants, dust and elbows, and it is milled thicker than the casing for exactly that reason. The apron hangs beneath it and closes the wall under the sill. Together they finish the bottom of the opening; casing alone leaves it reading unfinished.

Why the stool is matched to the window

The back edge of a stool carries a rabbet cut to the sash — the notch that lets it tuck under the window and sit flat on the sill framing. That dimension comes from the window, not from the room, which is why a replacement stool starts with a measurement at the opening rather than with a profile chosen from a catalogue. Get the rabbet wrong and the stool either rocks or stands proud of the sash.

  • Measure the depth from the face of the sash to the wall, and add the projection you want past the casing.
  • Measure the rabbet — the drop from the top of the stool to the surface it lands on.
  • Measure the wall angle. Jambs are rarely square to the wall; the ends get scribed.

Horns, and why the stool is longer than the opening

The stool runs past the casing at each end. Those extensions are horns, and their length is a proportion decision rather than a rule: enough to read as a deliberate shelf, not so much that the sill looks tacked on. A common starting point is the thickness of the casing plus the reveal, doubled — but the horn is set by eye against the room it is in.

The apron, and how it is returned

The apron is usually the casing profile run upside down, so the window reads as one assembly. It is cut to run from the outside of one casing leg to the outside of the other — stop it short and the step where it lands catches the eye every time you walk past. The ends are returned: the profile is mitred back on itself so it finishes rather than showing an open cut against the wall.

When you do not use a stool at all

Picture-frame casing treats the window like a door: four legs mitred around the opening, no stool and no apron. It is common in modern work and it is a legitimate choice, not a shortcut — but it commits you to a mitre at the bottom corners, where the two horizontal-to-vertical joints are the ones most likely to open.

Stool or sill?

WordWhat it meansWhere it is
StoolThe horizontal board the casings land onInside
SillThe sloped member that sheds waterOutside
ApronThe trim under the stoolInside
Drip capThe sloped moulding over the headOutside

Related products at UWP

Related questions

Terms on this page

Still picking? Email us with the details — stair height, run depth, existing stair condition — and we’ll tell you what we’d actually spec.

Ask the Houston team

Published 2026-09-17