Knotty Alder — hardwood for stair treads and millwork
Warm amber brown. Best when natural marks are part of the design intent.

590 lbf
Identical to clear alder on the scale — the knots are a grade decision, not a hardness one.
96 · red oak = 100
Indicative of lumber market position — not a UWP quote.
Milled to order · lead time confirmed at quote
Milled and finished at the Tanner Rd mill, NW Houston. Every wood stair part is special order.
What we mill it into
Character
Visible knots and casual movement.
Identical to clear alder on the scale — the knots are a grade decision, not a hardness one.
Best for
Rustic trim, doors, and character millwork.
How Knotty Alder behaves in service
Every board moves with the seasons, and in Houston the swing from a humid summer to a heated winter is the widest a floor or a tread will see. The figures below are the published shrinkage constants; the movement calculator turns them into inches for a given width.
7.3%
Across a flatsawn face, green to oven-dry. The larger of the two and the one a wide plank follows.
4.4%
Across a quartersawn face. Rift and quartered stock moves this much, which is why it is the stable cut.
USDA Wood Handbook
Published laboratory constants for the species, not a UWP measurement.
Finishing
Finishes exactly as clear alder does, with the knots taking stain darker. Open knots are filled before a film finish or left under oil.
Machining and fastening
The knots are the risk: they chip on the moulder and loosen if the board dries further after milling, so the stock is kiln-dried to the mill’s standard before it is run.
Closest in hardness
The three species nearest Knotty Alder on the Janka scale — the usual alternatives when a budget, a tone or a lead time rules it out.

