Skip to main content
Unique Wood Products

Cypress — hardwood for stair treads and millwork

Golden tan. Often selected for a relaxed, warm finish direction.

Cypress grain study
Janka hardnessSoft

510 lbf

The softest wood on this page. Spec it for the look and for rot resistance, never for wear.

Cost indexMid

124 · red oak = 100

Indicative of lumber market position — not a UWP quote.

Availability

Milled to order · lead time confirmed at quote

Milled and finished at the Tanner Rd mill, NW Houston. Every wood stair part is special order.

What we mill it into

Character

Soft grain and coastal warmth.

The softest wood on this page. Spec it for the look and for rot resistance, never for wear.

Best for

Custom millwork and specialty trim.

How Cypress behaves in service

Every board moves with the seasons, and in Houston the swing from a humid summer to a heated winter is the widest a floor or a tread will see. The figures below are the published shrinkage constants; the movement calculator turns them into inches for a given width.

Tangential shrinkageLow movement

6.2%

Across a flatsawn face, green to oven-dry. The larger of the two and the one a wide plank follows.

Radial shrinkage

3.8%

Across a quartersawn face. Rift and quartered stock moves this much, which is why it is the stable cut.

Basis

USDA Wood Handbook

Published laboratory constants for the species, not a UWP measurement.

Finishing

Yellow to honey under a clear coat and takes stain evenly. Its natural oils make it the domestic choice for exterior trim; a film finish outdoors will peel before the wood fails.

Machining and fastening

Soft and straight-grained, it machines easily but can be stringy on the cut. Holds fasteners moderately; pilot the ends.

Closest in hardness

The three species nearest Cypress on the Janka scale — the usual alternatives when a budget, a tone or a lead time rules it out.