Moulding & trim
Mitre
Also called miter
A joint where two pieces are each cut at half the corner angle so the profile continues around it.
A mitre carries a profile around a corner by splitting the angle between the two members. On a square outside corner that is 45 degrees each, but corners in buildings are rarely square and the joint should be cut to the angle actually measured.
Mitres open as wood shrinks, which is why inside corners on mouldings are usually coped instead — a coped joint closes rather than opens with movement.
Questions that use this term
See also
More in moulding & trim
Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.

