Skip to main content
Unique Wood Products

Moulding & trim

Corner mould

Also called outside corner, inside corner, corner guard

A moulding run at the meeting of two panelled faces, covering the joint instead of mitring it.

An outside corner wraps the arris where two panelled faces turn — a column, a bar front, the end of a wainscot run — so the board edges are covered rather than mitred. A mitre in solid wood at an outside corner opens the first dry winter; a corner mould does not.

An inside corner sits in the angle where two runs of beadboard or shiplap meet and absorbs whatever the walls are out of square, which is usually more than the eye expects.

Size follows the panel: a 3/4″ board wants a corner with a 3/4″ rabbet, so the mould sits down over the board rather than standing proud of it.

On this site

See also

More in moulding & trim

Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.