
PoplarPaint-Grade · Most Popular
Best for — Our highest-volume species. The value choice for painted trim, casing and built-ins — a lower-cost paint-grade hardwood for any profile finished in colour, not stain.
7-1/4" x 1.526" — milled to order in Houston. Any species; ground to match an existing profile on request.
Dimensions are nominal. Milled profile is held to ±1/64″ and length to ±1/16″ — tolerances and how each is measured. Hold a sample before you commit a run.
Shown lying flat, as it is milled. The spring angle could not be measured from this section — ask us to confirm it before you order.
White Oak · 7-1/4" × 1-1/2"
Crown · Ogee · Ornate
ORDER CODE
UW11133-725
quoted by the linear foot
Colour is indicative — grain and colour vary board to board.
Others on request — send us a sample or an offcut and we will match it.
One knife, 1 width. Length is a quantity — quoted by the linear foot.
The DXF is the finished section, in inches, for drawing reference. To match an existing profile instead, send us a sample or an offcut and we will grind a knife to it. Knife, setup and shop charges are on the custom moulding price schedule.
ORDER CODE
UW11133-725quoted by the linear foot
Specification · UW11133
White Oak · 7-1/4" width × 1-1/2" · Crown
Every profile in the library is milled to order, so the species is your choice rather than whatever happens to be on the shelf. These are the five we run most for crown — pick one in the swatches above to see this profile in it.

Best for — Our highest-volume species. The value choice for painted trim, casing and built-ins — a lower-cost paint-grade hardwood for any profile finished in colour, not stain.

Best for — The workhorse match for red oak floors — the most-stocked species across treads and moulding.

Best for — Cooler, modern, wire-brushed and natural finishes; the premium choice for light contemporary work.

Best for — Pale contemporary work, maple cabinetry, and anywhere an even near-white tone is wanted.

Best for — Dark, high-end interiors and feature work where a rich chocolate tone is the statement.
Crown moulding is sprung — it sits at an angle bridging the wall and ceiling, with an ornate profile that can include curves, beads, and steps. Cove moulding is a single concave curve, sitting flat into the wall-ceiling corner. Crown reads as traditional and substantial; cove reads as clean and quieter. For 8-foot ceilings, cove or small crown. For 9-foot+, scale up.
Read the answer →Cabinet crown molding sits on top of upper cabinets, finishing the cabinet-to-ceiling transition. Room crown moulding runs along the wall-ceiling seam around the rest of the room. These two crowns typically don’t coexist in the same kitchen — the cabinet crown is the dominant ceiling treatment when present, and room crown would visually compete. Use cabinet crown in kitchens with upper cabinets that reach close to the ceiling; use room crown elsewhere.
Read the answer →Calculate baseboard by measuring the perimeter of every room, subtracting door openings, then adding 10% for waste. Casing needs 17 to 20 linear feet per standard door, 14 to 17 per window. Crown takes the same perimeter as base. Shoe and quarter round match the base. The trim and casing calculator on our site does the math by room — feed in dimensions, get a total order list.
Read the answer →Yes. UWP runs custom knives to match existing baseboards, crown, casing, and any other milled profile. Bring us a 6-inch sample piece, a clean sketch with dimensions, or even a photo with a scale reference. We grind a new knife to match, run your order, and keep the knife on file for re-orders. One-time knife fee covers the setup; per-foot pricing matches our stock catalog.
Read the answer →