Moulding & trim
S4S
Also called surfaced four sides
Stock surfaced on all four faces to a finished dimension, with no profile run on it.
S4S is dimension stock rather than moulding: square-edged, sanded, and dimensioned, ready to be used as a flat trim board, a jamb, a shelf, or the blank a profile is later run from.
Its stated size is the finished size, unlike nominal lumber where a one-by is actually three quarters of an inch thick. S3S is the same thing surfaced on three sides, leaving one edge unfinished.
On this site
Questions that use this term
See also
More in moulding & trim
Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.

