Skip to main content
Unique Wood Products

Moulding & trim

Lattice

Also called lattice strip

The thinnest flat stock a mill runs — roughly 1/4″ to 5/16″ thick, an inch or two wide, edges eased.

Lattice is flat, thin and plain: no profile at all beyond the eased edges. It is the stock a screen, a trellis or a slatted panel is made from, and the lightest thing you can put over a seam in a paint-grade panel.

As a batten it reads as a line rather than as a board, which is the point — a full-thickness batten over a plywood seam changes the wall, and a lattice strip closes the joint without doing so.

Above about 5/16″ thick or a few inches wide the same job belongs to S4S board, which is dimensioned stock rather than strip.

On this site

See also

More in moulding & trim

Part of the UWP millwork glossary. Milled at the Tanner Rd mill, NW Houston.