
18 GA Galvanized Brad Nail — 1-1/4"
- Will-call code
- 18GA18125
- Spec
- 18 ga × 1-1/4"
- Pack
- 5,000 / box
- Pickup
- Tanner Rd, Houston
Galvanized premium-steel 18-gauge straight-collated brad nails, 1-1/4" long — 5,000 per box. Fits standard 18 ga straight finish/brad nailers.
Where it's used
Base shoe & quarter round
Base shoe and quarter round — nail into the base, not the floor.
Galvanized hold
Galvanized coating resists corrosion and helps the nail grip — fewer pops down the road.
Straight-collated
Straight stick collation for 18 ga finish/brad guns. Premium steel drives clean without bending in hardwood.
Pairs with: Base shoe (UW126) / quarter round (UW106), and 16 ga finish nails (16GA16200) for the baseboard itself.
Questions
Is 18 ga right for base shoe?
Yes — 18 ga brads are right for base shoe and quarter round. Nail into the baseboard (not the floor) so the shoe floats with seasonal movement. Use a 23 ga pinner + glue for delicate returns.
How do I order this?
Order by code at the will-call counter (NW Houston / Tanner Rd). Pricing is quoted at pickup. Open a cash account to streamline repeat orders.
Do you ship, or is it pickup only?
Will-call at the Tanner Rd yard (9915 Tanner Road, NW Houston), or Houston-metro delivery scheduled on the quote.
Fasten it. Finish it.
The baseboard, shoe, and quarter round these go on — pulled from the same yard so you leave with the whole job.
Questions people ask about the jobs these ride along with
How much trim do I need? A room-by-room calculation guide.
Calculate baseboard by measuring the perimeter of every room, subtracting door openings, then adding 10% for waste. Casing needs 17 to 20 linear feet per standard door, 14 to 17 per window. Crown takes the same perimeter as base. Shoe and quarter round match the base. The trim and casing calculator on our site does the math by room — feed in dimensions, get a total order list.
Read the answer →What trim goes where? A room-by-room guide.
Trim choice should read as a consistent system across the house, not a room-by-room patchwork. Baseboard and casing run everywhere, sized to ceiling height and door scale. Crown is reserved for formal rooms in traditional homes and skipped in modern ones. Chair rail and panel mould go in formal dining and entry. Stair trim ties the upstairs and downstairs together.
Read the answer →How do you install a tongue-and-groove ceiling?
Run the boards perpendicular to the joists, or add furring at 16 inches on centre if you need to run them the other way. Acclimate first. Start with the groove edge to the wall, blind-nail through the tongue shoulder at 45 degrees into every joist, and leave a 1/2 inch expansion gap at the perimeter for the trim to cover.
Read the answer →How do I install hardwood stair treads?
A confident DIYer can install a hardwood stair tread retrofit in a weekend. The sequence: pull carpet and staples, prep the substrate flat and quiet, acclimate the treads for 5 to 7 days, dry-fit each tread, glue with a urethane construction adhesive, fasten with stainless trim screws (countersunk), plug, sand, and finish. Risers go in before treads on a full build; after, on a retrofit.
Read the answer →




