Trim the whole room, before you order.
BASEBOARD · DOOR & WINDOW CASING · LINEAR FEET BY TYPE
Long wall, wall to wall.
Short wall, wall to wall.
36 = 3-0
80 = 6-8
Picture-frame casing (4 sides). For stool & apron, subtract the bottom leg and add your apron run.
Miter allowance.
Trim: 10–15%.
Optional · blended.
Openings and furniture are illustrative; the estimate uses the sizes and counts entered.
Measure door and window dimensions at the inside casing edges, including your reveal. Casing totals include the long points of each miter; opening positions in the illustration are approximate.
Baseboard, casing and crown are different profiles — order each by its own SKU. Doors assumed cased both sides.
Matching the trim? UWP mills baseboard, casing and crown profiles to spec across its core material program.
Request a quote →Estimates use one representative size per opening type. Openings in the visual are illustrative. Field-verify before ordering — final mill list is built per order.
Reference
Baseboard, casing, and the openings people forget
- How do I calculate baseboard for a room?
- Take the perimeter and subtract the door openings. A 14× 11 room is 50 linear feet around; two 36" doors remove 6 feet, leaving 44 feet of baseboard. Add waste on top — baseboard is mitered at every corner and each miter costs you material.
- How much casing does one door take?
- Two legs the height of the opening plus a head the width, and the head must run past the legs by the casing width at each end. A 36× 80 door in 3-1/2" casing is roughly 17 feet before waste. Order per opening rather than estimating the whole house at once — it is the openings, not the walls, that get miscounted.
- Should I subtract windows from baseboard?
- No. Baseboard runs under a window, so the wall length is unaffected. Windows only matter for casing. Doors are the openings that break the baseboard run.
- How much waste should I add to trim?
- 10% for a straightforward room. 15% where there are many corners, short walls between openings, or where the stock length forces splices. Short walls are the expensive case: a 3-foot return between two doors still costs you a full offcut at each end.

