Skip to main content
Unique Wood Products

What is brick mould, and when do I need it instead of casing?

Brick mould is exterior casing. It nails to the jamb of an exterior door or window and gives the brick, stucco or siding a clean edge to finish against. The standard face is 2 inches at about 1-1/4 inches thick, which is what pre-hung exterior units are built for — and what a replacement has to match once the masonry is laid.

The short version

  • It is casing, outdoors. Same job as interior casing: cover the joint between the frame and the wall.
  • 2″ face, about 1-1/4″ thick is the standard every pre-hung exterior unit is sized for.
  • Thickness matters more than profile on a replacement — the opening was built around it and the brick is already laid.
  • Specify for weather: primed for paint, or a species that takes an exterior finish.
  • A drip cap goes above it at the head, so water leaves the wall instead of tracking into the joint.

The full answer

Brick mould does outside what casing does inside — it covers the joint between the frame and the wall — with one extra job: it gives the masonry or the siding something definite to stop against. On a brick wall the mason works to it, which is why its dimensions matter more than its looks.

Why the 2-inch face is the standard

Almost every pre-hung exterior door and window is built for a 2″ face at roughly 1-1/4″ thick. The rough opening, the jamb width and the brick return are all sized around that. A heavier profile exists for wider reveals, but it is a decision made before the wall is built, not after.

Replacing brick mould on a finished wall

Once the masonry is laid, the opening is a fixed dimension. Match the thickness first: a profile that is thinner leaves a gap at the brick, a thicker one stands proud of it and cannot be caulked into looking right. The face width and the shape of the profile are the next decisions, and they are the ones you have room to choose.

  • Measure the existing piece at the head as well as the legs — a drip cap above it changes what fits.
  • Check the return to the brick; that dimension is what the mason left you.
  • Bring a sample or a section. A photograph of a painted wall tells a mill almost nothing about a profile.

Specifying it for weather

Brick mould is a weather detail as much as a trim detail. It is ordered primed for paint, or in a species that will take an exterior finish and hold it. Whatever the material, the end grain at the cuts is where failure starts, so the ends are sealed before the piece goes up — including the cut you make on site.

What goes with it

PieceWhere it goesWhat it does
Brick mouldAround the jambCovers the joint; the masonry stops against it
Drip capOver the headSheds water clear of the head joint
Sill / sill noseUnder the openingSheds water away from the wall below
CasingInside the same openingFinishes the joint on the interior face

Related products at UWP

Related questions

Terms on this page

Still picking? Email us with the details — stair height, run depth, existing stair condition — and we’ll tell you what we’d actually spec.

Ask the Houston team

Published 2026-09-17