============================================================================== SECTION 06 46 00 WOOD TRIM ============================================================================== Guide specification issued by Unique Wood Products, Houston, Texas. 9915 Tanner Road, Houston, TX 77041 · (713) 462-5045 HOW TO USE THIS SECTION Items in [brackets] are choices for the specifier. Each is a decision this document deliberately leaves open, not an omission — resolve or delete every bracket before issuing. Edit freely; this is a starting draft for your project manual. Tolerances and grade referenced below are published commitments and are stated with the method by which each is measured at https://www.uniquewoodproducts.com/professionals/standard. ============================================================================== PART 1 - GENERAL 1.01 Section includes interior standing and running trim: baseboard, base shoe, casing, crown, chair rail, panel mould, transitions and S4S stock. 1.02 Submittals: profile drawings at full scale for each moulding; 12″ samples of each profile in the specified species or primed finish. 1.03 Quality assurance: AWS Custom grade minimum; profiles matched to the Architect’s details or to the UWP profile numbers scheduled. PART 2 - PRODUCTS 2.01 Solid hardwood mouldings: [Red Oak] [White Oak] [Hickory] [Maple] [Walnut] [Poplar]; NHLA graded; 6–9% MC at delivery. 2.02 Paint-grade mouldings: finger-jointed, factory-primed pine; joints not visible after finishing. 2.03 Profiles: UWP stock profiles as scheduled by number, or custom knife ground to the Architect’s full-scale detail; profile tolerance ± 1/64″. 2.04 Lengths: random 8′–16′ unless scheduled; long lengths available for uninterrupted runs. PART 3 - EXECUTION 3.01 Install per the UWP Moulding & Trim Installation Guide. Cope inside corners; miter outside corners; scarf joints over framing. 3.02 Fasten with finish nails into framing at 16″ centers maximum; set and fill; back-prime paint-grade trim where it meets masonry or exterior walls. ============================================================================== END OF SECTION 06 46 00 ============================================================================== Source: https://www.uniquewoodproducts.com/professionals/specifications Free to edit and incorporate into a project manual. Confirm current content against the source before issuing.